Monthly Archives: October 2010

Good bearings

Posted on by
Reply

So, I finally figured out what the deal was with my accelerometer needing to be asked twice what the value was.

As it turns out, I wasn’t actually giving the chip time to reply. I thought the micro would automatically handle receiving the data value, so I all I had to do was send the ACK at the end. In fact, the command that sends the ACK actually tells the micro controller to wait until the entire data byte has been transmitted, and then transmits the ACK.

So, when I was storing the value before sending the ACK, I was storing the value that I originally had in the register (the address of the accelerometer chip) and then waiting for the data and finally sending the ACK. Now, I’ve changed it so that it waits for the data and sends the ACK before storing the data value in the register.

How did I figure all of this out? With an O-scope! I simply modified my code so that it would give me a voltage spike on one of the output pins while it was reading the data from the register. What I noticed was that it was spiking before it was supposed to. Here’s an example of what I mean:

 

Continue reading →

Punctual, but Problematic

Posted on by
1

So, you haven’t seen an update out of me in a while. This is because I’ve been struggling over the past week with getting my clock to return accurate, or at least consistently inaccurate results.

My test method was to use a little program that I wrote that would give me a 10 second count down before starting a timer that increments the LEDs once per minute. The idea was to use the 10 seconds to synchronize the timer with a timer known to be accurate and then let it run for a few hours and see how far off the minute mark it was. Take the number of seconds it’s off, divide by total number of seconds elapsed, and multiply by 1 million to get the parts per million (ppm) accuracy.

See, every crystal oscillator needs to be “tuned” with some Load Capacitors. I tried my best to match the Load Caps to the 22pF rating on the crystal’s spec sheet (even taking into account the parasitic capacitance on the breadboard), but I still couldn’t get good results.