QFN24 with no middle pad

Did you ever figure out a solution for your padless QFN chip mentioned here?

http://ch00ftech.com/2010/09/16/flow-and-reflow-are-riding-in-a-boat/#more-467

I may be using the MPU-6150(http://invensense.com/mems/gyro/sixaxis.html) for a project soon and although it has a center pad, it specifically says not to solder it to the PCB. Fairly strange… I’m thinking a little *very* precise hobby knife and tape work might work but was wondering if you had found a solution already.

Also, you’re the guy that made the shot counter. Very cool project, I saw it posted on reddit a while back.


Sure did?

http://ch00ftech.com/2010/10/05/good-bearings/

~ch00f


Also, that question mark was supposed to be an exclamation point. Damn iPad keyboard…

Leave a Reply

Your email address will not be published.